INSTRUCTIONS
MIXING INSTRUCTIONS OLYMPUS(TM) FLEX Herbicide must be applied with clean and properly calibrated equipment. Prior to adding OLYMPUS(TM) FLEX Herbicide to the spray tank, ensure that the spray tank, filters and nozzles have been thoroughly cleaned. In-line strainers and nozzle screens should be 50 mesh or coarser. 1. Fill the spray tank 1/4 to 1/2 full with clean water and begin agitation or bypass. 2. Add the appropriate rate of OLYMPUS(TM) FLEX Herbicide, as determined under the USE RATES section, directly to the spray tank. Maintain sufficient agitation during both mixing and application. OLYMPUS(TM) FLEX Herbicide should be fully dispersed in water before adding any other material. 3. Add the broadleaf weed herbicide. 4. Add the surfactant. 5. Fill the spray tank with balance of water needed. 6 Continue agitation during OLYMPUS(TM) FLEX Herbicide application to ensure uniform spray coverage. If the mixture is not continuously agitated, settling may occur. If settling occurs, thoroughly re-agitate spray solution for at least 10 minutes before application. Use spray solution within 24 hours after mixing. RE-SUSPENDING WG PRODUCTS IN SPRAY SOLUTION Like other Water Dispersible Granules or suspension concentrates (SC's), OLYMPUS(TM) FLEX Herbicide will settle if left standing without agitation. If the spray solution is allowed to settle for one hour or more, re-agitate the spray solution for a minimum of 15 minutes before application.

REENTRY PPE
PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with anything that has been treated such as plants, soil or water, is coveralls, socks, shoes, chemical resistant gloves such as barrier laminate, butyl rubber >= 14 mils, nitrile rubber >= 14 mils, or neoprene rubber >= 14 mils, and protective eye wear.

PPE
PERSONAL PROTECTIVE EQUIPMENT (PPE) Some materials that are chemical-resistant to this product are listed below. If you want more options, follow the instructions for category A on an EPA chemical resistance category selection chart. Applicators and other handlers must wear: Long-sleeved shirt and long pants, socks, shoes, chemical resistant gloves such as barrier laminate, butyl rubber >= 14 mils, nitrile rubber >= 14 mils, or neoprene rubber >= 14 mils, and protective eyewear (safety glasses). Follow manufacturer's instructions for cleaning/maintaining PPE. If no such instructions for washables, use detergent and hot water. Keep and wash PPE separately from other laundry.

TANK MIX
COMPATIBILITY If OLYMPUS(TM) FLEX Herbicide is to be tankmixed with other herbicides, compatibility should be tested prior to mixing. To test for compatibility, use a small container and mix a small amount (0.5 to 1 quart) of spray solution, combining all ingredients in the same ratio as the anticipated use. If any indications of physical incompatibility develop, do not use this mixture for spraying. Indications of incompatibility usually occur within 5-15 minutes after mixing. Indications of incompatibility include separation in the mix, and either clumping or clabbering of the mixture. Read and follow the label of each tankmix product used for precautionary statements, directions for use, geographic and other restrictions.