REENTRY PPE
PPE that is required for early entry to treated areas that is permitted under the Worker Protection Standard and that involves contact with anything that has been treated such as plants, soil or water, is coveralls over long-sleeved shirt and long pants, socks and shoes and chemical-resistant gloves made of any waterproof material such as polyethylene or polyvinyl chloride and protective eyewear.

PPE
PERSONAL PROTECTIVE EQUIPMENT (PPE) Some of the materials that are chemical-resistant to this product are listed below. If you want more options, follow the instructions for category A on an EPA chemical-resistance category selection chart. Applicators and other handlers must wear: Long-sleeved shirt and long pants, chemical-resistant gloves made of any waterproof material such as polyethylene or polyvinyl chloride, shoes plus socks and protective eye wear. When mixing/loading or cleaning equipment, wear a chemical resistant apron in addition to the other required PPE. Discard clothing and other absorbent materials that have been drenched or heavily contaminated with this product's concentrate. Do not reuse them. Follow manufacturer's instructions for cleaning/maintaining PPE. If no such instructions for washables exist, use detergent and hot water. Keep and wash PPE separately from other laundry.

TANK MIX
Mixing Instruction CAPRENO(TM) Herbicide must be applied with clean and properly calibrated equipment. Prior to adding CAPRENO(TM) Herbicide, ensure that the spray tank, filters and nozzles have been thoroughly cleaned and that agitation system is properly working. 1. Fill spray tank with 50% of the required volume of water, and begin agitation. 2. Agitate the CAPRENO(TM) Herbicide product container by shaking, circulating, or stirring prior to adding the herbicide into the spray tank. 3. Add the appropriate amount of CAPRENO(TM) Herbicide slowly to the spray tank or mixing system and ensure complete dispersion. Maintain and ensure thorough dispersion and sufficient agitation during both mixing and spraying. 4. If tank mixing with another pesticide, add the tank mix product next. 5. Add nitrogen fertilizer. 6. Add the adjuvant. 7. Fill the spray tank with balance of water needed. If ammonium sulfate (AMS) is the nitrogen fertilizer source, it is preferred that the AMS go into the tank after the CAPRENO(TM) Herbicide and before other tankmix partners or adjuvants. Compatibility If CAPRENO(TM) Herbicide is to be tank mixed with other pesticides, compatibility must be tested prior to mixing. To test for compatibility, use a small container and mix a small amount (0.5 to 1qt) of spray solution, combining all ingredients in the same ratio as the anticipated use. If any indications of physical incompatibility develop, do not use this mixture for spraying. Indications of incompatibility usually occur within 5-15 minutes after mixing. If the mixture balls-up, or forms flakes, sludges, gels, oily films or layers, or other precipitates, it is not compatible and the tank mix combination should not be used. TANK MIX RECOMMENDATIONS Certain tank mixes may aid in the performance of CAPRENO(TM) Herbicide. See Spray Additives section of this label for recommendations for adjuvant partners used in conjunction with CAPRENO(TM) Herbicide. When using CAPRENO(TM) Herbicide in tank mix combinations, read and follow all parts of tank mix partner labels. Follow the directions of the most restrictive tank mix partner label.